烤漆房废气怎么处理，喷漆房催化燃烧废气处理设备介绍伸缩式喷漆房是为解决较大型工件移动运送困难而研制的实用型产品,烤漆区可根据产量大小，任意调整，充分利用生产场地和操作空间。

　　How to treat the exhaust gas in the paint baking room? Introduction to catalytic combustion exhaust gas treatment equipment in the paint baking room. The telescopic paint baking room is a practical product developed to solve the difficulty of moving and transporting larger workpieces. The paint baking area can be adjusted according to the production volume, making full use of the production site and operating space.

　　涂装世界伸缩式喷漆房注意事项1、在进行喷涂前先检查喷涂的气压是否正常，同时确认系统清洁；

　　Precautions for the retractable paint booth in the painting world: 1. Before spraying, check whether the air pressure is normal and confirm that the system is clean;

　　2、检查空气压缩机和油 水微尘分离器，使喷漆软管保持洁净；3、喷枪、喷漆软管和调漆罐要存放在干净的地方；

　　2. Check the air compressor and oil-water dust separator to keep the paint hose clean; 3. Spray guns, spray hoses, and paint mixing tanks should be stored in clean places;

　　4、除了用吹风枪和粘尘布除尘外，其它所有喷涂前的工序都应该在烤漆房外完成；

　　4. Except for using a hair dryer and adhesive cloth to remove dust, all other pre spraying processes should be completed outside the paint booth;

　　5、在烤漆房只能进行喷涂和烘烤工序，而且烤漆房房门只可在车辆进出时开启，开启房门时开动喷涂时的空气循环系统以产生正压，确保房外的灰尘不能进入房内。

　　5. In the paint baking room, only spraying and baking processes can be carried out, and the door of the paint baking room can only be opened when vehicles enter and exit. When opening the door, the air circulation system during spraying is activated to generate positive pressure, ensuring that dust outside the room cannot enter the room.

　　6、穿着指定的喷漆服和佩戴防护用具才能进入烤漆房进行操作；

　　6. Wear designated spray paint clothing and protective equipment before entering the paint booth for operations;

　　7、在进行烘烤作业时，将烤漆房内的易燃物品拿出房外

　　7. When performing baking operations, remove flammable materials from the paint booth outside the room

　　8、非必要人员，不得进入烤漆房。

　　8. Non essential personnel are not allowed to enter the paint booth.

　　喷漆房的维护保养：

　　Maintenance and upkeep of the paint booth:

　　1、每天清洁房内墙壁、玻璃及地台底座，以免灰尘和漆尘积聚；

　　1. Clean the walls, glass, and floor bases in the room every day to prevent the accumulation of dust and paint dust;

　　2、每星期清洁进风隔尘网，检查排气隔尘网是否有积塞，如房内气压无故增加时，更换排气隔尘网；

　　2. Clean the intake dust screen every week and check if there are any blockages in the exhaust dust screen. If the air pressure in the room increases inexplicably, replace the exhaust dust screen;

　　3、每工作150h应更换地台隔尘纤维棉；

　　3. The platform dust isolation fiber cotton should be replaced every 150 hours of work;

　　4、每工作30oh应更换进风隔尘网；

　　4. The air inlet dust screen should be replaced every 30 hours of work;

　　5、每月清洁地台水盘，并清洗燃烧器上的柴油过滤装置；

　　5. Clean the floor water tray monthly and clean the diesel filtration device on the burner;

　　6、每个季度应检查进风和排风电动机的传动皮带是否；

　　6. Check the drive belts of the intake and exhaust motors every quarter;

　　7、每半年应清洁整个烤漆房及地台网，检查循环风活门、进风及排风机轴承，检查燃烧器的排烟通道，清洁油箱内的沉积物，清洗烤漆房水性保护膜并重新喷涂；

　　7. Every six months, the entire paint baking room and floor net should be cleaned, the circulating air valve, inlet and exhaust fan bearings should be checked, the exhaust passage of the burner should be checked, the sediment in the oil tank should be cleaned, the water-based protective film in the paint baking room should be cleaned and re sprayed;

　　8、每年应清洁整个转换器，包括燃烧室及排烟通道，每年或每工作1200h应更换烤漆房顶棉。

　　8. The entire converter, including the combustion chamber and exhaust duct, should be cleaned annually, and the painted roof cotton should be replaced every year or every 1200 hours of operation.

　　本文由  伸缩式喷漆房  友情奉献.更多有关的知识请点击  http://www.sdcjtz.com/   真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

　　This article is a friendly contribution from the retractable paint booth For more related knowledge, please click http://www.sdcjtz.com/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.

上一篇：工业涂装流水线：涂装生产流水线的工艺流程
下一篇：